Milkman Sound The Amp 50W
What is The Amp? First and foremost, it’s a 50W Guitar amplifier. The preamp is based around a single 12AX7 running at high voltage in a discrete Class-A circuit. The tube preamp reacts with a guitar the same way any tube amplifier does: it generates harmonics and the sweet-sounding high fidelity tone that tubes are known for. Along with tube EQ. there are on-board reverb and tremolo effects so that The Amp can be used as a grab-and-go amplifier. Footswitches for bypassing the effects are built-in. A Class D power section delivers 50 watts into 8ohms or 100 watts into 4ohms. The Speakon combination jack for speaker output takes either a standard 1/4” connection or a locking Speakon connector for extra security.
The Amp has an integrated headphone amplifier that sounds identical to the output from a speaker. This is perfect for practice, auditioning pedals, or for those times when noise is not appropriate. The Amp can operate with no speaker attached, so it can live on a pedalboard and go wherever the pedals go. Speaking of travel, The Amp has a universal IEC power input. It can run from 100 to 260 VAC. No matter where it is on Earth, it can be plugged into a wall socket and used with no need for additional power accessories.
How about a compact studio-quality tube preamp? The internal XLR output delivers a balanced line-level output. There is no modeling or simulation involved, no menus or presets to give option anxiety. It is very straightforward and simple to get great tone from the tube preamp of The Amp and use it as the front end for a modeling system, recording setup, or for playing direct on stage.
The Amp also has “pedal level” output where it can be used as the front end of a pedalboard or as an amp-like effect on the back end of a pedalboard. There is no substitute for the marriage between a magnetic guitar pickup and the first stage of a tube amplifier, and this is something that is missing with modern pedalboard setups. Using The Amp in front of a pedal chain will add harmonics and tube musicality to the entire signal chain starting right where it matters most: between a guitar pickup and the grid of a tube.
Using The Amp further down the signal chain creates unique tonal possibilities. It plays well with pedals, and it can add extra EQ or reverb to an existing amplifier. The Amp can drive the input of an amplifier as an extra tube gain stage. It can be a backup for a vintage amp needing service or used in place of anemic backline gear on your travel gig. At 2.5lbs, and with so many different uses, The Amp may be your new best friend.
This amp is available for pre-order. We take your payment now and will get in touch once the amp is ready to be shipped.
This one will be shipped out from the US.
- Model: Milkman Sound The Amp 50W